IndiceBRTableOfContents |
Introduzione
testo
Titolo 1
Does Linux like your PDA?
1) Connect your Pocket PC and type "dmesg" in a shell to see if the ipaq kernel module is loaded. The output might look like the following. Take note of the tty used for the connection. Code:
usb 4-2: new full speed USB device using uhci_hcd and address 3 ipaq 4-2:1.0: PocketPC PDA converter detected usb 4-2: PocketPC PDA converter now attached to ttyUSB0
2) Optionally, you can use "cat /proc/bus/usb/devices" to check for a USB device that's using the ipaq kernel module. Code:
T: Bus=04 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#= 4 Spd=12 MxCh= 0 D: Ver= 1.01 Cls=ff(vend.) Sub=ff Prot=ff MxPS=16 #Cfgs= 1 P: Vendor=413c ProdID=4002 Rev= 0.00 C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 2mA I: If#= 0 Alt= 0 #EPs= 2 Cls=ff(vend.) Sub=ff Prot=ff Driver=ipaq E: Ad=81(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
Titolo 1
) Install the required packages for SynCE: Code:
sudo apt-get install librra0 librra0-tools librapi2-tools libsynce0 synce-dccm synce-multisync-plugin synce-serial
2) synce-serial setup will be invoked by apt, follow this through using the default settings, unless you have reason to do otherwise. Code:
/dev/ttyUSB0 local address: 192.168.131.102 remote address: 192.168.131.201 no dns entry needed
3) Perform the following the following command to tell SynCE where to look. This seems redundant, but doesn't hurt. Code:
sudo synce-serial-config ttyUSB0
4) Start the SynCE connection daemon by typing "dccm" in a shell. Use "dccm -p password" if your Pocket PC is password protected. 5) Initiate a serial connection by typing "sudo synce-serial-start" in a shell. You should be greeted with "synce-serial-start is now waiting for your device to connect". 6) "synce-pstatus" shows a LOT of information about your Pocket PC, such as current mode of operation, battery charge level, memory usage as well as backup battery status. If you want to see some other synce commands, type "dpkg -L librapi2-tools". You can use these commands to do things such as installing Pocket PC programs, etc. 7) Create the partnership between the Pocket PC and your computer. There are 2 slots on the device, so the INDEX can be 1 or 2. Code:
synce-matchmaker create INDEX
You should be greeted with: Code:
Partnership creation succeeded. Using partnership index INDEX.
Titolo 1
testo
Titolo 1
testo
